Basic Gpon setup with inband management

Comments

Post a Comment

Popular posts from this blog

Huawei OLT how to Add into U2000 NMS

Image
Huawei OLT SNMP parameters snmp-agent syntax enable snmp-agent sys-info version v2c             snmp-agent community read public1234 snmp-agent community write private1234 snmp-agent target-host trap-hostname NMSRV address 192.168.16.200 udp-port 162 trap-paramsname NMS                  snmp-agent target-host trap-paramsname NMS v2C securityname NMS snmp-agent trap enable standard      snmp-agent trap-format standard snmp-agent trap source vlanif 991
Read more

Huawei OLT How to set command alias

Image
How to set command alias in Huawei OLT setup command alias you can use the command: # command alias ipconfig "display ip interface brief" now type "ipconfig" Show board 0 OR board 0/0 information # command alias board00 "display board 0/0" Now type board00 How to remove alias  undo command alias ipconfig  undo command alias board00
Read more

How to configure NTP server

Image
How to Install NTP Using Chrony in RHEL 8 NTP (Network Time Protocol) is a protocol which runs over port 123 UDP. NTP synchronize clients time and date with a master server. Chrony is a default NTP client as well as an NTP server on Red Hat Enterprise Linux 8. Service name = chronyd Install chrony on system # dnf install chrony -y # yum install chrony -y Now start the chronyd service, enable it to auto start at system boot and verify the running status: # systemctl start chronyd # systemctl status chronyd # systemctl enable chronyd Now Configure NTP Server Using Chrony: set up your RHEL 8 server a master NTP time server. Open the /etc/chrony.conf: # vim /etc/chrony.conf Now search for the “allow” configuration directive and uncomment it and set the network addresses from which the clients are allowed: #allow 192.168.0.0/16 now save and exit Restart the chronyd service # systemctl restart chronyd Now op...
Read more