Huawei OLT How to set command alias



How to set command alias in Huawei OLT

setup command alias you can use the command:

# command alias ipconfig "display ip interface brief"

now type "ipconfig"


Show board 0 OR board 0/0 information

# command alias board00 "display board 0/0"

Now type board00

How to remove alias 


undo command alias ipconfig 

undo command alias board00


Comments

Post a Comment

Popular posts from this blog

Huawei OLT how to Add into U2000 NMS

Image
Huawei OLT SNMP parameters snmp-agent syntax enable snmp-agent sys-info version v2c             snmp-agent community read public1234 snmp-agent community write private1234 snmp-agent target-host trap-hostname NMSRV address 192.168.16.200 udp-port 162 trap-paramsname NMS                  snmp-agent target-host trap-paramsname NMS v2C securityname NMS snmp-agent trap enable standard      snmp-agent trap-format standard snmp-agent trap source vlanif 991
Read more

How to configure NTP server

Image
How to Install NTP Using Chrony in RHEL 8 NTP (Network Time Protocol) is a protocol which runs over port 123 UDP. NTP synchronize clients time and date with a master server. Chrony is a default NTP client as well as an NTP server on Red Hat Enterprise Linux 8. Service name = chronyd Install chrony on system # dnf install chrony -y # yum install chrony -y Now start the chronyd service, enable it to auto start at system boot and verify the running status: # systemctl start chronyd # systemctl status chronyd # systemctl enable chronyd Now Configure NTP Server Using Chrony: set up your RHEL 8 server a master NTP time server. Open the /etc/chrony.conf: # vim /etc/chrony.conf Now search for the “allow” configuration directive and uncomment it and set the network addresses from which the clients are allowed: #allow 192.168.0.0/16 now save and exit Restart the chronyd service # systemctl restart chronyd Now op...
Read more

How to install caching only dns server on Rhel 8 / Centos 8

Image
How to install caching only DNS server in RedHat 8 / Centos 8 package name = bind service name = named port number = 53 rndc port = 953 rndc it uses only the loopback address, rndc is used to manage the name server. First install the required packages using yum or dnf: Yum install bind bind-utils -y Take the backup of named.conf before configuration: Cp -p /etc/named.conf /etc/named.conf.orig Information about bind “named” package: rpm -qi bind exploring files and directories of bind “named” server: rpm -ql bind Now configure dns server open the file “vim /etc/named.conf” and make changes: [root@itsummation ~]# vim /etc/named.conf // options {           listen-on port 53 { localhost ; 192.168.56.12; };                                                  ...
Read more